1300 859 933
www.evoheat.com.au
Command-i Series Manual
Page 4
3. Safety Instructions
Installation, repair, or relocations must only be done by a fully qualified technician. If done incorrectly there is
a number of hazards that can occur including fire, electric shock, water leakage and injury.
•
When an abnormality (smell of burning, etc.) occurs, stop the unit and disconnect the power or turn off the
breaker. If the unit continues to be operated in an abnormal condition, it may cause a fire or hazards.
•
Do not insert fingers or objects into the fans or evaporator of the unit.
•
Installation, repair or relocations must be done by a fully qualified person and not by the customer. If done
incorrectly it may cause fire, electric shock, water leakage and other hazards.
•
For unit cleaning or maintenance, switch off and disconnect the power of the unit.
•
Do not spray insecticides or flammable sprays around the unit, it may cause a fire or damage the unit’s
cabinet.
•
Do not install the unit near flammable gas or spray flammable substances near it.
•
Ensure the heat pump is installed on a strong and stable platform.
•
A circuit breaker must be installed for the unit.
•
Use supply wires suitable for 75C.
•
The heat pump located inside the unit is equipped with an over-load protection system. It does not allow for
the unit to start for at least 3 minutes from a previous stoppage.
•
Copper or iron must not be used as a fuse. An electrician must use the correct fuse for the heat pump.
•
Make sure that the unit and power connection have good earthing.
•
If the supply cord is damaged, it must be replaced by the manufacturer, our service agent or a similarly
qualified person in order to avoid a hazard.
•
Caution: Single wall heat exchanger, not suitable for potable water connection.
Содержание COMMAND-i
Страница 1: ......
