Assembly and Maintenance
IPC-820
- 21 -
Item
Description
Item
Description
Item
Description
1
Clip bar bracket
2
Copper hexagon
screw (as the case
may require)
3 Motherboard
4
2X rubber spring
pad
5
2X truss head
M3*6
6
Binding
strip
7
4X cup head M4*6
screws with
external
teeth lock washers
8
M3*8 screws with
washer (as the case
may require)
9
Carrier
board
10 IO
bracket
Installing FSC(EPI) motherboards:
1. According to the number of mounting holes of the carrier board, use same number
of copper hexagon screws CH-M3-8-5-Ni (for EPI carrier board, it is copper hexagon
screws CH-M3-7.5-5-N) and lock them in the chassis;
2. Use proper number of M3*8 screws with washers to fasten the carrier board;
3. By the corresponding slot, insert the motherboard on the carrier board, use two
M3X6 screws to fasten the bracket of the motherboard and CPU backplane bracket
respectively onto the IO bracket and clip bar bracket;;
4. Install the rubber spring pad on the corresponding binding strip. Please be aware
that slot direction of the rubber spring pad must be consistent with the direction of
PCB board of the motherboard;
5. Put the two binding strips with rubber spring pad on the installation position of the
chassis, make the slot of the rubber spring pad click onto the PCB board of the
motherboard, finally use four cup head M4*6 screws with external teeth lock washers
to fasten them.
Содержание IPC-820
