Thank you for your purchase of our company’s products. This system has been
manufactured following current technical safety regulations and is in compliance with
AS/NZ60335 standard.
Please read this instruction booklet carefully before installing the system.
It contains important information on personal and user safety measures to be followed while
installing, using, and carrying out maintenance work on the equipment. Once the product
has been installed, please hand this booklet to the end user.
TRANSPORT AND MANIPULATION
The packaging used for this system has been designed to support normal transporting
conditions. The product must always be transported in its original packaging as not doing so
could deform or damage the product. Do not place heavy weights on the packaging and
avoid knocking or dropping it.
Check that the apparatus is in perfect condition while unpacking. Do not accept delivery if
the apparatus is not in its original packaging or shows clear signs of having been
manipulated in any way. Any fault or damage caused in origin is covered by our company
guarantee. Please make sure that the apparatus coincides with the product you have
ordered and that the details on the rating label fulfil your requirements.
The product should be stored in a dry place in its original packaging, protected from dust
and dirt until it is installed in its final location.
IMPORTANT INFORMATION
Installation must only be carried out by qualified persons. Make sure that the installation
complies with the applicable building and electrical regulations. The fan appliance must not
be used in explosive or corrosive atmospheres. The duct system must be used exclusively
for the ventilation system.
The appliance is not intended for use by young children or infirm persons unless they have
been adequately supervised by a responsible person to ensure that they can use the
appliance safely. Young children should be supervised to ensure that they do not play with
the appliance.
ELECTRICAL CONNECTION
The ventilation fan must be connected to a single-phase mains network, with the specific
voltage and frequency according to the specifications on the fan rating label.
The electrical installation must include an isolating switch with a contact clearance of at least
3 mm, correctly sized and in accordance with the electrical standards.
Earthing is not required as this fan has double insulation (Class II).
If the fan model you have purchased is not fitted with a power cord then please note that it
must be wired with a fixed permanent connection. Disconnect the mains supply before
making any electrical connection. If in any doubt contact a registered electrician.
SAFETY DURING INSTALLATION
Make sure there are no loose elements near the fan, as they could run the risk of being
sucked up by it. When connecting the fan to the ducting, check that the ducting is clean of
any element that could be sucked up by the fan. During installation of the fan, make sure
that all the fittings are in place and that the structure which supports it is resistant enough
to bear its weight at full functioning power.
Fans may have a delayed start-up time or operate under the control of their inbuilt
electronics. Always take extreme care as the unit may start unexpectedly. Before carrying
out any maintenance, make sure the mains supply is disconnected, even if the machine is
switched off. Never insert your hands into the inlet side of the fan without first unplugging
the fan.
Содержание Home Ventilation
Страница 6: ...4 Room Sample Layout ...
Страница 7: ...6 Room Sample Layout ...