Everyway Comfy EMS, Инструкция по эксплуатации, Страница: 8 / 17

13 12
CAUTION
Do not insert the plug of the patient lead wire into the AC power
supply socket.
Chapter 14: LEAD WIRE MAINTENANCE
Clean the wires by wiping with a damp cloth. Coating them lightly
with talcum powder will reduce tangling and prolong life.
Chapter 15: ELECTRODE OPTIONS
The electrodes are disposable and should be routinely replaced
when they start to lose their adhesive nature. If you are unsure of
your electrode adhesive properties, order replacement electrodes.
Replacement electrodes should be re-ordered through or on the
advice of your physician to ensure proper quality. Follow application
procedures outlined in electrode packing, to maintain optimal stimula-
tion and to prevent skin irritation.
Chapter 16: ELECTRODE PLACEMENT
The placement of electrodes can be one of the most important pa-
rameters in achieving success with EMS therapy. Of utmost impor-
tance is the willingness of the physician to try the various styles of
electrode placement to find which method best fits the needs of the
individual patient.
Every patient responds to electrical stimulation differently and their
needs may vary from the conventional settings suggested here. If
the initial results are not positive, speak to your physician about
alternative stimulation settings and/or electrode placements. Once
an acceptable placement has been achieved, mark down the elec-
trodes sites and the settings, so the patient can easily continue
treatment at home.
4) Place the electrode on your body as directed by your physician.
5) Slowly turn on the device by rotating the Intensity control
(ON/OFF Switch) knobs.
6) Select the mode and settings as directed by your physician.
7) Slowly increase or decrease the intensity as directed by your
physician by rotating the Intensity control (ON/OFF Switch) clock
wise to increase, counter clockwise to decrease.
After
Treatment, Turn the device off by rotating the Intensity control
(ON/OFF Switch) counter clockwise to the zero setting.
Chapter 13: ATTACHMENT OF ELECTRODE
LEAD WIRES
The wires provided with the system insert into the jack sockets
located on top of the device. Holding the insulated portion of the
connector, push the plug end of the wire into one of the jacks (see
drawing); one or two sets of wires may be used.
After connecting the wires to the stimulator, attach each wire to
an electrode. Use care when you plug and unplug the wires.
Jerking the wire instead of holding the insulated connector body
may cause wire breakage.