EverWarm
Radiant Floors
PAGE 9
S E C T I O N 1
2.
Adders (A, A2, A3, A4): Adders are
used to attach one sheet of Heating Film
to another, when a thermostat cold lead
connection is not required. Adders are
available in 120 volt and 240 volt
configurations. To add a single sheet
of Heating Film to a 120 volt system, an
“A-120” (A indicates one additional
sheet, 120 indicates the voltage) would
be required. To add two sheets to an
existing sheet, use an A2. To add three sheets, an A3 will be required.
An A4 will connect up to four sheets to an existing sheet or sheet set.
3.
Jumper (JP-60): A Jumper can be
used to reconnect a copper bus bar if it
has been cut for completion of the
layout. The Jumper is sixty (60”) inches
in length and can be used on both 120
volt and 240 volt systems. They are
helpful for going through door ways,
around corners, around posts, and
around columns. Jumpers can also be
used around cut outs for floor ports
such as receptacles, registers, and floor ports.
ADDER
JUMPER
