PAGE 6
1
S E C T I O N 1
SPECIFICATIONS FOR HEATING FILM:
Applications: Indoor floor heating.
Listings: UL Listed for U.S. and Canada under
UL 1693 and CAN/CSA C22.2 No.
130.2-93, File No. 20140325-
E465902, ETL 4007353, CE 120509,
TUV K5140/E112
Controls:Heating Film must be controlled by a
CarbonicHeat approved direct voltage
Floor heat-sensing thermostat.
Voltage:120 VAC Max 100 sq. ft. (9.29 sq.m)
50/60hz,
240 VAC Max 200 sq. ft. (18.58 sq.m)
50/60 Hz
Watts: 15 W/sq. ft. (51 BTU/sq. ft.), 166.1 W/sq.m
Maximum circuit load: 15 Amp
Maximum circuit overload protection: 20 Amp breaker GFCI: (Ground Fault
Circuit Interrupter) required for each circuit (included in the thermostat control).
Maximum bend radius: Not to exceed 90 degrees. Do not crease Heating Film.
Maximum exposure temperature: (Continuous and storage) 150ºF (65.5ºC)
Minimum installation temperature: 50ºF (10ºC)
SKILL REQUIREMENTS:
Installation must be performed by qualified persons, in accordance with local
codes, ANSI/NFPA 70 (NEC Article 424), and CEC Part 1 Section 62 where
applicable. All electrical work must be installed in accordance with Article 424 Part
IX of the National Electric Code (NEC) ANSI/NFPA 70. “STATEMENT OF
NATIONAL ELECTRIC CODE PRODUCT COMPLIANCE (NEC). This product
from
EverWarm Radiant Heat
™ Corporation is compliant to Article 424, Part
IX of the National Electric Code (NEC), “Electric Radiant Heating Sheets and
Heating Sheet Sets” and as a Heating Sheet Set. Electrical installations must use
a Terminal Junction Assembly manufactured only by CarbonicHeat™ Corporation
per NEC 424.96 (2)”.
THANK YOU FOR SELECTING
EverWarm Radiant Heat
®
This informational manual is provided as a guide to installing
EverWarm Radiant Heat
Film, including design suggestions,
installation steps, precautions, limitations, and floor covering
guidelines.
EverWarm Radiant Heat
