evertz TSMIP-10GE, Руководство пользователя

Страница: 17 / 50

TSMIP-10GE Series
IP Transport Stream Monitor
Revision 1.0
Page-9
3.3. CONNECTING DEVICE TO COMPUTER
a. Plug in a standard Ethernet cable (Cat 5e) from computer’s Ethernet port to the Ethernet
switch where the TSMIP is connected.
b. Power On the device.
c. On the computer screen, select “Start” in the bottom left corner. Then select “Control
Panel”. Search for the “Network and Sharing Center” icon and double click it. Double click
on “Change adapter settings”. Select “Local Area Connection” and click the “properties”
button. Following that, select “Internet Protocol (TCP/IPv4)” and click the “properties” button
again. Select the button labelled “Use the following IP address” and click “ok”. Enter in an
IP address that is on the same subnet as the TSMIP with the same subnet mask and
gateway.
d. Now check communication with the device. Select “Start” in the bottom left corner of the
computer screen. Then select “Run...” and in the space provided enter “cmd” followed by
clicking the “ok” button. In the command prompt type “ipconfig” and push the Enter key, this
will confirm the IP address has been set on your computer. Type in “ping” followed by the IP
address of the TSMIP and press the Enter key again; if the IP address replies then you are
connected. If “Request timed out” appears then there is a network problem.