evertz EQX-IP18-IPG, Руководство пользователя

Страница: 21 / 54

EQX–IP18-IPG
EQX Input and IP Gateway Module
Revision 1.0
Page - 11
5.
SETTING GENLOCK REFERENCE
On the front of the EQX–IP18-IPG module, there is a four position dip switch that is used to select the
reference standard to be used for genlock.
Figure 5-1: Location of Dip Switch on the EQX–IP18-IPG Module
Moving the dip switch position will change state to open or closed. When a dip switch is up, means the
open position is selected. When a dip switch is down, means the closed position is selected. Figure
5-5-2 illustrates the open position.
Figure 5-2: Illustration of Dip Switch
5.1. NTSC REFERENCE
Step 1 : Make sure the NTSC reference signal is provided to the EQX frame.
Step 2 : Set the dip switch at the EQX-IP18-IPG card edge position to the following:
Switch Pin State
1 Open
2
Open
3 Open
4 Closed (down / close to board)
Table 5-1:
Card Edge Dip Switch Settings for NTSC Reference
All pins are in open position.