evertz EMX Series, Руководство пользователя

Страница: 23 / 28

EMX Series Multiframes
Revision 1.6
Page - 15
4. INSTALLING AND REMOVING THE MODULES
4.1. ELECTRO STATIC DISCHARGE (ESD) PRECAUTIONS
All semiconductor devices are sensitive to ESD. To prevent any damage or
degradation on components of the product caused by ESD, observe these
precautions when installing or removing modules from the frame.
1. Discharge static from your body. Wear a grounded anti-static wrist or heel strap, to discharge the
static voltage from your body.
2. Use a Safe Work Area. Avoid handling modules in areas that have a floor or work surface covering
capable of generating a static charge. Also nothing capable of generating or holding a static charge
should be allowed in the work area.
3. Handle ESD sensitive modules carefully. Do not slide modules over any surface. Do not touch
exposed connector pins. Pick-up modules by the edges of the modules, never by touching exposed
leads.
4. Transport and store sensitive components or assemblies in a static-protected bag or container.
4.2. RESTRICTED ACCESS AREA
This equipment is intended only for use in a restricted access area.
A restricted access area is defined as an area accessible only to skilled persons and instructed persons
with the proper authorization.
4.3. INSTALLING THE MODULE REAR PLATES
Each module is shipped with a matching rear panel plate which houses the connectors appropriate for the
module. When installing a rear plate, locate the desired slot position where you wish to install the rear
plate. Make a note of the slot number where you are installing the rear plate. Orient the plate so that the
labeling is visible when the plate is installed. Loosely fasten the plate to the extrusions using the mounting
screws provided, beginning with the top screw. You will tighten the screws after the main module is
installed.
4.4. OPENING AND CLOSING THE FRONT PANEL
The front panel is used as a fire enclosure. The door should be kept closed
except when servicing the equipment.