7880IPG-NAT Series
High Density Network Address Translator
Page - 10
Revision 2.1
3) Engineering Debug Tool
This menu is for Evertz technical support staff only. You may be requested to access and
execute options within this menu when seeking technical support from Evertz. Guidance will be
given should this be required.
2.4.
CONFIGURING THE BASIC NETWORK SETTINGS FOR THE CONTROL PORT
Now select option (1)
Network Setup
, the Network Configuration menu will be displayed as shown in
Error! Reference source not found.
.
Error! Reference source not found.
1. Select option (1)
Set IP Address
and configure the IP address for the 7880IPG-NAT ensuring
that the IP address is not already in use on the network.
2. Now select option (2)
Set Netmask
and configure the correct subnet mask for your network.
3. If required also configure option (3)
Set Gateway
and (4)
Set Broadcast Address.
4. Enter
(X) to go one level up
.
5. From the main menu in Figure 2-5, enter
(X)
to save and apply settings.
Power Cycle the 7880IPG-NAT to ensure all changes are applied and saved to the card. Connect an
RJ45 cable to the Control Port of the device. Verify the network connectivity by opening the command
window and try to ping the 7880IPG-NAT using the IP address that was set. Make sure your computer
is on the same subnet before trying to ping.
If you are not configuring SNMP settings, you have now completed the minimum necessary network
configuration and can connect the cables to the rear card when ready.
Содержание 7880IPG-NAT Series
Страница 2: ...This page left intentionally blank ...
