7780MD Series
DVB-S/S2/S2X L-Band and IF Satellite Modulators
Revision 1.0
Page - 19
UDP Port:
This parameter sets the UDP port (default = 1234). It shall be an even number as required
by RTP standard.
Multicast Address:
This parameter sets multicast group address (default = 224.1.2.2). It is only used
in multicast reception mode.
Reception Time Out:
This parameter sets the UDP reception timeout in seconds from 0 to 120.
Latency Receiver:
This parameter sets the latency of the receiver in number of Ethernet frames from
10 to 3500. Default = 150.
IGMPV3 Monitor
IP Preset:
This is the IP address set and stored as preset in firmware.
IP Status:
This is the IP address read from the module.
IP Input Monitoring
Protocol:
This parameter displays the protocol detected.
FEC Mode:
This parameter displays the FEC mode.
FER:
This parameter displays the estimated Packet Error Rate (PER) before applying FEC.
Corrected Frames:
This parameter is a corrected packet counter. It is always null in none FEC mode.
Uncorrected Frames:
This parameter is an uncorrected packet counter. If not null, some MPEG TS
packets will be missing in the output stream.
Received Frames:
This parameter displays the number of received frames.
Number TS Frames:
This parameter displays the number of MPEG TS packets per IP packet.
