l
Prior to mounting, keep in mind that the motion
sensor is most sensitive to the motion, which is
across the detection field and less sensitive to the
motion, which moves directly towards the
detector.
(FIGURE 2)
SENSOR SENSOR
LESS SENSITIVE MORE SENSITIVE
SENSITIVITY TO MOTION
FIGURE 2
INSTALLATION
To facilitate installation, it is essential to get a drill and
a screwdriver ready. Select a location for the unit based
on the coverage angles shown in FIGURE 3.
FIGURE 3
Install a wall switch adjacent to the power source.
(FIGURE 4 & 5) This helps
you operate AUTO and
MANUAL OVERRIDE with ease. See page 4 for
further information.
Type I:
FIGURE 4
Type II:
FIGURE 5
2
Note : The detection angle of ES34T can come up to180°.
However to reduce or localize its detection coverage, use
the small plastic slip(s) provided to cover up part(s) of the
LENS, thus reducing its detection angle. (FIGURE 6)
FIGURE 6
WIRING INSTRUCTION
(1) Switch off the power source or wall switch.
(2) Unscrew two front screws to detach the base cover
from the unit. (FIGURE 7)
(3) Make use of the base cover as a template to mark
the position of two screw holes on the wall. Drill
the wall and screw the base cover onto the wall
using suitable plastic wall plugs and screws
provided. (FIGURE 8).
FIGURE 8
(4) Strip approximately 6-8mm insulating part of the
wires from the power cord. Before connection,
run the wires through the rubber seal provided.
Note: The power cord must meet H05RN-F,
1.0mm² requirement.
3
