Note:
If the LED blinks steadily for 30 seconds followed by 3 rapid flashes, this
means the binding was unsuccessful. Abort and repeat steps 4 to 6 above.
8. Once binding is complete, switch off the AC mains power again.
9. With the AC mains turned off, assemble and secure the curtain controller inside
the electrical box to avoid any physical contact with user.
10. Switch the AC mains on again when complete. The controller is ready to use.
Auto Calibration
This lets the controller automatically measure the entire length of the curtain. Once
calibrated, the curtain can moved accurately to any position when set remotely by
the user.
1. Go to Select “System” and select the Curtain Controller
2. Choose the type of curtain: Shade or Blinds.
Shade calibration
3. Click the “Calibration” button to start. The motor will proceed to move,
completing two full cycles of up, down and up again.
4. When calibration is complete, a “Done” will appear.
Blinds calibration
3. First, calibrate the up/down movement by clicking the “Calibration” button. The
motor will proceed to move, completing two full cycles of up, down and up
again.
4. When calibration is complete, a “Done” will appear.
5. To calibrate the tilting angle of the blinds slat, first enter an estimated time
period needed for a full turn of the slats. The aim is to set a time period just long
enough for a full turn of the slats but short enough to prevent any movement of
the blinds. Setting this too long will not only turn the slats but will also move the
blinds upwards. The default period is 0.5 seconds.
6. After entering the time, click “Submit” and wait for “Done” message to register
the new time.
7. Click “Run” and observe the results.