2
6. Plug the Smart Plug into an electrical outlet.
7. The screen below will appear in 10 seconds if the process is successful.
8. Time-out will occur if the binding process was unsuccessful. Please try with
“Manual binding”.
Manual Binding
1.
Repeat steps 3 to 5
of the “Binding with a gateway” section.
2.
With the plug in Off position (LED is Off) press and hold the On/Off button for more
than 3 seconds until the LED blinks rapidly. A 30-second countdown will start.
3.
Within 5 seconds, the LED indicator will then stop flashing and turn off, indicating
the learning procedure is completed. The screen below will appear indicating the
process is successful.
Operation
Remote ON/Off control:
Select “Automation”, then click on the power button to turn ON/OFF the device.
Manual ON/Off control:
Toggle the button for On or Off. Press the button and the LED will turn on,
and the electronic device controlled by AN132 will also turn on, while pressing
the button again will turn off the electronic device and its LED will turn off as
well.
Note
: The Plug has an overload protection feature. Upon detecting an
overload condition, it will automatically switch off the load, disable the On/
Off button and the LED will flash rapidly for 30 seconds as warning. When
this happens, disconnect the load and check the load for symptoms of failure.
The overload protection of the Plug can be reset by simply unplugging the
Plug and re-connecting it to the electrical outlet.
Safety Precautions
1.
Do not put the unit in humid or dusty places or facing direct sunlight.
2.
The suitable ambient temperature for the unit is 0°C - +40°C.
3.
Do not place the unit near combustible substances or any source of heat,
e.g. fire,
radiators, boilers, etc.
4.
The unit body will become a little hot after putting to use, which is perfectly
normal.
