EverSewn sparrow 15, Инструкция по эксплуатации

Страница: 18 / 52

Inserting bobbin
Attention:
Turn power switch to off ("O") before inserting or
removing the bobbin.
When inserting or removing the bobbin, the
needle must be fully raised.
1. Remove the sewing table, then open the
hinged cover.
2. Pull the bobbin case (a).
4. Hold the bobbin case with one hand. Insert
the bobbin so that the thread runs in a
clockwise direction (arrow).
5. Pull the thread through the slit and under the
finger. Leave a 6 inch tail of thread.
6. Hold the bobbin case by the hinged latch.
by the hinged latch
3. Remove the bobbin of the bobbin case.
7. Make sure the bobbin case finger (b) fits into
the notch (c) at the top of the race as shown.
Note:
If the bobbin case is not properly placed back
into the machine, it will fall out of the shuttle
immediately after starting to sew.
6
4
2 1
a
16
5 3
c
b
7
sparrow 15