5. LOADING THE TAPE
Use scissors to cut the end of the tape so that it has a clean,
square end to allow it to feed under the drive wheel.
Remove the upper tape guide plate. Now see Figure 1, pass
the tape over the rear guide roller and forward toward the
drive wheel. Push down on the drive wheel lifter, while
passing the tape under the drive wheel, pushing it forward
until it meets the cutter blade. Release the drive wheel lifter.
6. TAPE GUIDE PLATE INSTALLATION
Check that the upper tape guide plate is the correct way up.
Install the upper tape guide plate as shown below.
Evers GmbH Graf-Zeppelin-Str. 10 46149 Oberhausen T49 208 99475-0 T49 208 99475-31 [email protected] eversgmbh.de
