EverRide Fury EFRKW1948S, Руководство владельца/оператора

Страница: 10 / 40

GB - 10
Check Tire Pressure
See SPECIFICATIONS on page 37.
Check Engine Oil
Refer to Engine Manual.
Check Hydraulic Oil
See Checking Hydraulic Fluid Level on
page 21.
Lubricate Unit
Ensure that all grease fittings are lubricated.
See Lubrication Points on page 19.
Check Safety Interlock System
See Safety Interlock System on page 12.
Check Function of All Controls
Ensure unit runs and performs properly.
1. Start the engine and allow the unit to
warm for 2 – 3 minutes. Disengage the
parking brake. The unit should remain
stationary with no creep. See Checking
Neutral Creep on page 22.
2. Drive unit and note tracking. The unit
should travel in a straight line with both
steering levers in the full forward
position (see Adjusting Maximum Speed
Drift on page 23).
Check Deck Adjustments
1. Check height-of-cut deck adjustments.
The deck should have the ability to be
adjusted to all heights of cut. See Mower
Lift Pedal on page 14.
2. Check side-to-side and front-to-rear
deck level. The front of the deck should
be 1/8 – 1/4 in. lower than the rear. See
Checking Blade Level and Pitch on
page 25.
3. Adjust deck to position 3 on the height of
cut indicator. Verify 3” cut height with cut
height gauge.
PRE-DELIVERY SETUP
CAUTION: Avoid injury!
Explosive separation of tire and
rim parts is possible when they
are serviced incorrectly:
• Do not attempt to mount a
tire without the proper
equipment and experience
to perform the job.
• Do not inflate the tires
above the recommended
pressure.
• Do not weld or heat a
wheel and tire assembly.
Heat can cause an
increase in air pressure
resulting in an explosion.
Welding can structurally
weaken or deform the
wheel.
• Do not stand in front or
over the tire assembly
when inflating. Use a clip-
on chuck and extension
hose long enough to allow
you to stand to one side.
WARNING: Safety interlock
system failure and improper
operation of unit can result in
death or serious injury. Test this
system each time unit is
operated. If this system does not
function as described, do not
operate until repairs are made.