Everlast PowerPlasma 100S, Руководство оператора

Страница: 13 / 32

13
QUICK SETUP AND USE GUIDE Section 2
GAS
INLET
1~220 VAC
1~220 V
IMPORTANT: ALWAYS CONSULT A LICENSED ELECTRICIAN AND LOCAL CODES BEFORE RE
-
WIRING YOUR WELDER OR ATTEMPTING TO MAKE ANY ELECTRICAL CONNECTION.
NEMA 6 - 50P
L2,WHITE; HOT (240V 1 PHASE)
L1,BLACK; HOT (240V 1 PHASE)
QUICK SETUP GUIDE: REAR CONNECTIONS AND WIRING
(US/Canada)
SUPPLIED PLUG IS A NEMA 6-50P , THE STANDARD PLUG FOR
MOST 1 PHASE 240 V WELDERS IN THE US AND CANADA.
1
2
3
4
PUSH TO CONNECT TUBING
IMPORTANT: TO PREVENT AIR LEAKS, MAKE SURE TUBING ENDS ARE SQUARELY CUT
AND FULLY INSERTED. TO RELEASE TUBING: PRESS GENTLY ON PLASTIC COLLAR SO
THAT IT COMPRESSES INTO HOUSING AND THEN PULL TUBING OUT.
GREEN GROUND (220/240V 1 PHASE)
NOTE: WHEN ASSEMBLING AIR REGULATOR NOTICE THE MARKINGS THAT ARE STAMPED
ON TOP OF THE REGULATOR HOUSING FOR AIR FLOW DIRECTION. AIR FLOW DIRECTION
WILL BE NOTED AS IN/OUT OR BE STAMPED WITH A SMALL ARROW FOR AIR FLOW DI-
RECTION. THE QUICK CONNECT 1/4” MALE AUTOMOTIVE COUPLING SHOULD BE MOUNT-
ED ON THE SIDE OF THE REGULATOR WITH “IN” OR THE ARROW POINTING TO THE MID-
DLE OF THE REGULATOR. ALSO THE BRASS PLUG INCLUDED WITH THE ACCESSORY
PACKAGE SHOULD BE MOUNTED IN THE CENTER HOLE.
Not Pictured: L3,RED; HOT (240V 3
PHASE Opt. for PP 100S) Use a 3 phase
rated plug for this application or wire
all wires directly to panel.