Customer Service 1-888-707-1880
Or email [email protected] 18 Dyaco Canada Inc.©2019
HOW TO ADJUST THE REED SWITCH
The reed switch should be adjusted if the console does not display correct feedback.
The first step to remove the end cap ( 53) and flange nut (39 ), then use the special tools (crank puller not
included) to remove the right / left crank.
The second step to remove all self
‐
tapping screws ( 62) on the left and right chain cover and then take
off the left and right chain cover (54&55) and front cover (56 ) from main frame .
The third step is to loosen the screw (61), rotate the lower sensor wire (69) aligned with the magnet on the
pulley until the computer receive signals and tighten the screw (61).
The last step is attach the left and right chain cover (54&55 ) & front cover ( 56) & crank (15&16) on main
frame.
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling, even when the resistance is adjusted to the
highest level, the drive belt may need to be adjusted.
The first step to remove the end cap ( 53) and flange nut (39 ), then use the special tools (crank puller not
included) to remove the right / left crank.
The second step to remove all self tapping screws (
‐
62) on the left and right chain cover and then take
off the left and right chain cover ( 54&55) and front cover (56 ) from main frame .
The third step is to loosen or tighten the flywheel adjuster (36) to adjust the belt tension.
The last step is attach the left and right chain cover (54&55 ) & front cover ( 56) & crank (15&16 ) on main
frame.
