rubber supporting pad
screw
lower base cover
Installing
the
rubber
supporting pad
If
there is a rubber supporting pad and a
screw provided in a plastic bag with your
a p p l i a n c e , y o u c a n i n s t a l l t h e s e
accessories according to the following
procedure.
Note:
There is no need to install these
accessories under normal usage.
Only under the extreme circumstances,
cabinet empty while load on door with
total mass of 10 kg and opening the door
about 90 degree ,this refrigerator may
take risk of tipping. Then rubber
supporting pad should be fastened to
the lower base cover to steady this
appliance.
1.Tilt appliance to find screw hole on the
left of lower base cover.
2.Put screw into the hole of rubber
supporting pad.
3.Make screw in alignment with the hole
on lower base cover . Fasten rubber
supporting pad to the base cover firmly
by a cross screw driver (self-provided).
Leveling
The appliance should be level in order to
eliminate vibration. To make the appliance
level, it should be upright and both
adjusters should be firmly contacted with
the floor. You can also adjust the level by
screwing out the appropriate level
adjusterat the front (use your fingers or a
suitable spanner).
Electrical connection
Caution!
Any electrical work required to
install this appliance should be carried out
by a qualified or competent person.
Warning!
This appliance must be earthed.
The manufacture declines any liability
should these safety measures not be
observe.
cross screwdrawer
8