Everglades EVBI630, Инструкция по эксплуатации

Страница: 16 / 63

16
Temperature is not properly
adjusted.
Please look in the “initial Start
Up” section.
Door was open for an extended
period.
Open the door only as long as
necessary.
A large quantity of warm food was
placed in the appliance within the
last 24 hours.
Turn the temperature
regulation to a colder setting
temporarily.
The food is too warm.
The appliance is near a heat
source.
Please look in the “installation
location” section.
Interior lighting does not
work.
Light bulb is defective. Please look in the “changing
the Light Bulb “section.
Heavy build-up of frost,
possibly also on the door
seal.
Door seal is not air-tight(possibly
after reversing the door).
Carefully warm the leaking
sections of the door seal with a
hair dryer(on a cool setting). At
the same time shape the
warmed door seal by hand
such that it sits correctly.
Appliance is not level. Readjust the feet.
The appliance is touching the wall
or other objects.
Move the appliance slightly.
Unusual noises.
A component, e.g. a pipe, on the
rear of the appliance is touching
another part of the appliance or the
wall.
If necessary, carefully bend the
component out of the way.
The compressor does not
start immediately after
changing the temperature
setting.
This is normal, no error has
occurred.
The compressor starts after a
period of time.
Water on the floor or storage
shelves.
Water drain hole is blocked. See the “cleaning and care”
section.
Changing the light bulb
Warning!
Before changing the light bulb, switch off the appliance and unplug it, or pull the fuse or
the circuit breaker.
Light bulb data: 220-240V, max. 15 W
To switch off the appliance, set the temperature regulator to position “0”.
Unplug the mains plug.
To change the light bulb, undo the screw.
Press the light bulb cover as shown and slide it backwards.
Change the defective light bulb.
Refit the light bulb cover and the screw.
Put the refrigerator back into operation.