EMV400 FHD Mobile DVR
3
Front Panel
FHD
1
7
9
5
3
4
6
8
1 10
2
No. Name
Description
1
USB2.0 Port
Three USB2.0 ports for connecting to the USB storage device or
mouse.
2
HDD Drive Tray
Install a 2.5” HDD for recording.
3
SD Card Slot
Insert a SD / SDHC card (up to 32GB) for alarm event backup
recording (see 2.3 SD Card Installation). To enable the SD card
function, see 6.4.1 Alarm in the User’s Manual. You can also see
Tested SD Cards in 2.3 SD Card Installation
for tested card brands.
4
Function Key
This Function key is
currently reserved
.
5
IR Receiver
Receives data from the infrared remote control.
6
System LEDs
•
Alarm:
Turns on when the connected alarm I/O is triggered;
turns off when the alarm I/O stops being triggered.
•
GPS:
Turns on continuously when the mobile DVR is receiving
GPS data.
•
System Fail:
Turns off when system is acting normally. Turns on
when these events occur: System Clock Error / Fan Fail / Disk
Temperature Over / Disk Fail / Disk Off / Network Loss.
•
Heater:
Blinks when heater on; off blinking when heater off.
•
HD R/W:
Blinks when the HDD is reading or writing.
•
Power:
Turns on continuously when the power is supplied.
Blinks when Battery power error occurs (lower than 9V or
higher than 36V) or 12VDC power supply error.
7
Main Monitor
RCA video output for connecting to a monitor for live view,
playback and displaying OSD.
Note
this mobile DVR has three Main Monitor outputs, one on the
front panel and the other two on the rear panel. All of the Main
Monitor ports can be connected simultaneously.
8
HDD Key Lock
Lock and unlock the HDD tray.
9
Audio Out
RCA audio output for connecting to the speakers. The audio output
only works during playback. Speakers with a (built-in) amplifier and
external power supply are required.
10 Ethernet Port
One RJ-45 port for connecting to the network.
