Operation – Using the Pump (continued)
23
7. Discontinue
use if
clogged or
inoperative
If the pump becomes clogged or inoperative during use, discontinue use
immediately.
- DO NOT attempt to service while chemicals are in the pump and power is
connected.
- Return to service area to review instructions for troubleshooting before
attempting to service.
CAUTION
DO NOT
operate the pump at pressures which cause the motor to exceed the amperes rating
indicated on the name plate.
Improper adjustment of the pressure switch setting may cause severe overload or premature
failure. Failures due to improper adjustment of the pressure switch setting will not be
covered under the warranty.
“Intermittent Duty” is defined as: operated and/or frequently started within a period of time
that would cause the motor to reach its maximum thermal limits. Once the maximum
thermal limit is obtained, the motor must be allowed to return to ambient temperature before
resuming operation.
Note: A reserve, clean container capable of holding at least the volume of the entire pump system
should be kept for use when the pump system needs to be emptied temporarily for repairs. It is
advisable to purchase a reserve tank suitable for pesticide storage for use in these circumstances.
The container should be properly labeled as to its contents if it is used.
Step Three: Clean pump and decontaminate after use.
When done using the sprayer, it is important to clean the pump and decontaminate yourself. Do not
store the pump when saturated with chemicals, as it is unsafe and could also result in damage to the
equipment.
WARNING
Cleanup and decontamination procedures must be followed after each use.
Improper equipment cleanup and disposal of chemicals can result in dangerous chemical
exposure to humans and the environment, as well as equipment damage.
Personal decontamination is required after spraying to minimize unsafe exposure to chemicals
and potential illness.
1. Drain pump
system
If there is excess pesticide left in the pump system, drain the pump
system:
a) Disconnect power to the pump and relieve system pressure by pulling
the spray gun trigger.
b) Find a suitable container in which to drain the unused pesticide.
c) While wearing rubber gloves, eye protection, and all other required
personal protective equipment, allow pesticide to drain into container.