HEAT LIVE RELAX
GETTING STARTED
1
. Carefully remove the heater body, heater base and remote control from their plastic bags and the carton, and place on a
clean bench.
2. With the heater body on its side, unscrew the base nut from the bottom. Place the base over the tread and re-attach the base
nut. Hand tighten the nut.
3. Place the heater upright onto a stable, flat and dry surface. Take care the power cord is fully unfurled.
4. Plug the cord set into a 230-240V~A.C. 50Hz electrical outlet. Turn the power on at the electrical outlet and at the power
switch at the rear of the appliance. Power on will be indicated by a short “beep”.
5. The heater is now ready for use. Refer to the operating instructions section further in this manual for the full operation of
your heater.
OPERATING INSTRUCTIONS
POWER ON/OFF BUTTON
Make sure the power supply and power switch are on, a short audible “beep will indicate the appliance is in standby mode.
Press the Power On/Off Button once and the unit will now be active and the Power Indicator will light up. The appliance will
start at the low power setting (25°C), oscillation off, fan on, with the digital display showing the current ambient temperature.
Press a second time and the appliance will revert back to the standby mode.
Note: If the Temperature is set to a level below the ambient temperature, the unit will not run.
TEMPERATURE/TIME SET BUTTON
The appliance starts with the timer off and the temperature set to (25°C). Pressing the Temperature/Time Set Button once puts
the appliance into the timer set mode (“H” flashing on the digital display twice a second). Set the time using the Setting Increase
Button & Setting Decrease Buttons (“+” & “-“) to adjust the time to turn off in hours (between 1 & 12 hours). To fix time, either
leave for 5 seconds or press the Elements On/Off or Oscillation buttons. The timer can be disabled by turning the appliance
off or resetting the timer to “0”.
Pressing the Temperature/Time Set Button twice (or once more while in the timer set mode) puts the appliance into the
temperature setting mode (°C flashes on the display). Set the maximum temperature using the Setting Increase Button & Setting
Decrease Buttons (“+” & “-“) to adjust the maximum temperature in °C (between 15°C & 35°C). To store this, either leave for
5 seconds or press the Elements On/Off or Oscillation buttons. When the appliance detects this temperature has been reached
it will turn the elements off until the temperature drops 2°C below the set temperature, at which point the elements will turn
back on. Note: The appliance will generally run for 10 seconds while the ambient temperature is measured.
OSCILLATION BUTTON
The appliance starts with the oscillation off. Press the Oscillation Button once and the heater body will oscillate on the base (the
Oscillation Display will light up). The heater will continue to oscillate until the Oscillation Button is pressed again (the
Oscillation Display will turn off), or the Power On/Off Button is pressed to send the appliance into the standby mode.
ELEMENTS ON/OFF BUTTON
The appliance starts with only half of the available heating elements running. Press the Elements On/Off button to switch
between low & high power.
Base Nut
Base nut
Base
Heater Body
Heater Body
