HEAT LIVE RELAX
SAFETY FEATURES
1. A thermal overload protector is built in to prevent overheating.
2. When an overheat temperature is reached, the heater will automatically shut off. It can only resume operation
when the user resets the unit (see reset instructions below).
To reset your heater:
1.
Unplug the heater and wait between 5-10 minutes for the unit to cool down.
2.
Then, turn on the unit again and operate normally.
CLEANING & MAINTENANCE
WARNING:
ALWAYS UNPLUG THE CORD BEFORE MOVING OR SERVICING, DO NOT
IMMERSE HEATER IN WATER!
Take the Air Inlet and the Air Filter off, clean the Air Inlet with the vacuum brush attachment on your
Vacuum cleaner, and wash the Air Filter in warm water and dry it. DO NOT DRY AIR FILTER IN
DIRECT SUNLIGHT. Clean the body of the heater with a soft damp cloth. Always make sure that the
heater is completely dry before connecting back to the mains supply.
CAUTION: Do not use gasoline, benzene, thinner, harsh cleaners, etc. as they will damage the
heater. NEVER use ALCOHOL OR SOLVENTS.
STORAGE: Store the heater with these instructions in the original packaging, in a cool, dry place.
WEEE WARNING
This product should not be disposed of with household waste. Please recycle where facilities exist and
check with your local authority for recycling advice.
HINTS & TIPS
Where possible your electric heater should be connected to a power outlet
that uses a separate 10 amp power circuit. This will avoid overloading your
household fuse.
In the event that your household fuse is overloaded and trips, please note this is
normally caused by the use of excessive power outlets at the same time your heater
is operating (for example, a steam iron, kettle, toaster etc.). Please ensure to check
the use of the power circuit and adjust when heater is in use (i.e. turn off the heater
when boiling a kettle).
Should you still experience difficulty contact Everdure Service for assistance.