EASY DECISION
LUBRICATION OF THE GAS TAPS
This can only be performed by an authorized person. It may be required if the gas taps become stiff and
difficult to turn.
LEAK TESTING
1.
Make sure gas control knobs are Off and turn the cylinder valve On.
2.
Check for leaking joints by brushing with solution of half-liquid detergent and half water. If a leak is
present, bubbles will appear (or you may hear a hissing sound). Retightening connections can
generally repair a leaking joint. You must also check the gas hose and connection at the gas cylinder.
If a leak cannot be resolved, do not proceed.
DO NOT USE NAKED FLAME FOR LOCATING GAS LEAKS.
IF A LEAK PERSISTS CALL AN AUTHORISED GAS FITTER.
NOTE: If an appliance cannot be adjusted to perform correctly, contact Everdure service department.
ELECTRICAL CONNECTIONS
LOCAL AUTHORITY REQUIREMENTS
Installation is only permitted by an authorized person, and carried out according to instructions provided by
the manufacturer. Incorrect installation might cause harm and damage which the manufacturer accepts no
responsibility. The electrical connection can be found 40mm in from the rear edge and 270mm from the left
hand side (looking from the front).
INSTALLATION
This cooktop must be connected to a 220-240V 50Hz power supply. It is earthed via the cord.
Before carrying out the connection to the power supply, the voltage rating of the appliance (stamped on
the appliance identification plate) must be checked for correspondence to the available mains supply
voltage, and the mains electric wiring should be capable of handling the hob’s power rating (also indicated
on the identification plate);
The power point must be connected to a suitable earth wiring, in conformity to current safety regulations.
Ensure that the power supply is within 900mm of the cooktop. The power supply cord must not touch
against any hot surfaces and must be placed so that its temperature does not exceed 75 degrees C at any
point along its length.
The colours of the wires in the hob power cable may not correspond with the colours marked on the
terminals of your electrical plug .The plug should in any case be wired as follows:
—connect the green/yellow wire to the terminal marked with the letter E or the earth symbol or coloured
green/yellow;
—connect the blue wire to the terminal marked with the letter N or coloured black;
—connect the brown wire to the terminal marked with the letter L or coloured red.
7
