776-3758
3
Rev. 07/21/14
WARNING
FAILURE TO OBSERVE THESE WARNINGS COULD RE SULT IN IN JU RY.
3. Extreme or awkward finger, wrist, or arm positions.
4. Excessive duration of the activity.
5. Vibration.
6. Repeated pressure on a body part.
7. Working in cold temperatures.
CTD's can also be caused by sports activities. Pain, tingling,
or numbness in the shoulder, forearm, wrist, hands, or fingers,
especially during the night, may be early symptoms of a CTD.
Do not ignore them. Should you experience any such symptoms,
see a physician immediately. Other early symptoms may include
vague discomfort in the hand, loss of manual dexterity, and
nonspecific pain in the arm. Ignoring early symptoms and
continued repetitive use of the arm, wrist, and hand can lead
to a serious disability.
wArNiNg:
Handling the brass parts of this product will expose you
to lead, a chemical known to the State of California to cause birth
defects and other reproductive harm.
Wash hands after handling
.
IMPORTANT PRECAUTION INFORMATION - READ BEFORE
USING THIS SPRAY GUN
:
sPrAy guN descriPtioN
The 776-3758 is a light weight, anodized aluminum, general
purpose gravity feed spray gun designed for use in various types
of spraying applications. The 776-3758 can handle water based
and solvent based spraying applications.
iMPortANt:
This spray gun may be used with most common
coating and finishing materials. It is designed for use with mildly
corrosive and non-abrasive materials. If used with other high
corrosive or abrasive materials, it must be expected that frequent
and thorough cleaning will be required and the necessity for
replacement of parts will be increased.
HVLP MODEL 776-3758
This HVLP spray gun was manufactured to provide maximum
transfer efficiency by limiting air cap pressure to 10 psig (complies
with rules issued by SCAQMD and other EPA air quality authorities).
This HVLP spray gun will produce approximately 10 psig cap
pressure at 36-43 psig gun inlet pressure, as measured at the gun
inlet. An air cap test kit should be used to insure 10 psig cap
pressure is not exceeded. Order test kit part number RSTK58.
For maximum transfer efficiency, do not use more pressure than
is necessary to atomize the material being applied.
Connect the gun to a clean, moisture and oil free air supply using
a hose size of at least 5/16" I.D. hose. Do not use 1/4" I.D. hose.
(25' x 1/4" hose at 18 cfm has a pressure loss of 25 psig. 25' x
5/16" hose at 18 cfm has a pressure loss of 8 psig.)
