Everbilt ZE00802A, Быстрый старт

Страница: 3 / 23

Non-Submersible Transfer Pump
Read your manual for installation, operation, and safety information. This guide neither supplements
nor replaces the Owner’s Manual.
DO NOT RUN PUMP DRY!
Dry running will void the warranty and damage pump.
Quick Start Guide
NO COILS!
NO KINKS!
2. Attach the clear suction hose (included) to the suction
strainer (included) by pushing the male threaded end into the
rubber coupler on the suction strainer. Then place the strainer in
at least 1/2 in. of water at the lowest point to be pumped.
NOTICE: Make sure the connection is airtight. An air leak can
cause the pump to run dry.
4. Thread a 5/8 in. or larger garden hose (sold separately, max
50 ft. length) to the discharge outlet on the pump.
NOTICE: Make sure the end of the outlet hose is not under water.
If the outlet is under water, the pump may not work.
NOTICE: Never operate this pump unless it is secured to a solid
foundation. 6. To operate, plug the pump into a GFCI outlet.
NOTICE: This pump can be very loud when plugged in.
THIS IS NORMAL. Once water begins to pump, the noise
will lessen.
When the water level has been reduced to approximately 1/8 in.,
you MUST UNPLUG THE PUMP. DO NOT RUN DRY. The pump will be
EXTREMELY LOUD when the pump is no longer pumping water.
NOTICE: If water is not pumped in 30 seconds, unplug the power
cord and check the connection on the two ends of the inlet hose
to make sure there are no air leaks. Then, add water into the
inlet again and repeat the process.
3. Thread the other end of the clear suction hose onto the suction
inlet of the pump.
NOTICE: Always ensure the washer in the hose connector is not
damaged. An airtight seal is necessary for this pump to operate.
Make sure the clear hose and suction strainer are in the water
before plugging the pump in.
1. Add water (approximately 1-2 Tbsp.) into the inlet to wet
the impeller of the pump.
5. Attach the pump to a sturdy base (table, board, etc.)
to prevent it from tipping over. Make sure the hoses are
as straight as possible.
WARNING: This pump CANNOT be submersed in
water, and the motor CANNOT get wet at all. Getting
the motor wet could cause electrocution, which could
lead to serious injury or death!
NOTICE: Do not coil or kink the hose.