Eventide H9000, Руководство пользователя

Страница: 69 / 143

69
o
Expression Pedal
o
2 expression Pedals
o
1 Expression Pedal + 1 Aux Switch
o
1 Aux 1 Expression Pedal
o
2 button Aux Switch
o
3 button Aux switch
After you have selected the mode appropriate for your connected switch/pedal,
press the Enter key to save your selection.
Calibrating Your Attached Pedals and Switches
Once you have selected your desired type of pedal/switch hardware you are using,
the H9000 will populate the rest of the display with relevant calibration tools.

Use the cursor button and the Enter key to navigate to and engage the
“Calibrate” field.

If you have attached an on/off type pedal, physically press on it and make
sure that you see the appropriate “SW” circle illuminates. There are separate
SW circles for 1, 2 or 3 button pedals.

If you have attached a continuous foot pedal, navigate to the “Calibrate Pedal”
field, then sweep the pedal back and forth with your foot. You should see the
Calibrate Pedal field display a range between 0-100% on the calibration
meter.

When you’ve finished calibrating, disengage the “Calibrate” button using the
Enter key.
Note: Even though there are only two pedal/switch connectors on the H9000, you
can connect up to four pedals. This is made possible by connecting two pedals to
each connector, using a “Y” cable such as the “Hosa YPP-117 ¼-inch TRS to Dual ¼-
inch TSF Stereo Breakout cable”.
This capability is possible because:

In the external control section of the parameters mode, there are 4
expression pedals listed.

In set-up mode, there are options to configure a single connector to be
connected to two separate expression pedals.