www.event-lighting.com.au
3
Safety Instructions
Warning
•
Do not open this device, there are no user-serviceable parts inside.
•
Do not look at the light source when the device is on.
•
This unit's housing may be hot during and after operation.
•
Install this device in a location with adequate ventilation, at least 20 inches (50 cm) from
adjacent surfaces.
•
Do not leave any flammable material within 50 cm of this unit while operating or
connected to power.
•
Do not operate this device outdoors or in any location where dust, excessive heat, water,
or humidity may affect it.
•
Do not operate this device if the housing, lenses, or cables appear damaged.
•
Do not connect this device to a dimmer or rheostat.
•
ONLY connect this device to a grounded and protected circuit.
•
ONLY use the hanging bracket to carry this device.
•
In case of a serious operating problem, stop using immediately.
•
The maximum ambient temperature is 104° F (40° C). Do not operate this device at
higher temperatures.
Power Input and Power Linking
This device has an auto-switching power supply work with input voltage range of 100~240 VAC,
50/60 Hz. Link up to the maximum of 8A. DO NOT exceed this amount.
Product Installation
•
This device can be mounted in many orientations provided each individual device is
secured by the use of correct mounting bracket.
•
Use a safety chain when mounting this device overhead.
Fuse Replacement
If the fine wire fuse of the device fuses, replace it with a fuse of the same type and rating. Before
replacing the fuse, unplug the mains lead. Procedure:
•
Unscrew the fuse holder on the rear panel.
•
Remove the old fuse from the fuse holder.
•
Install the new fuse into the fuse holder.
•
Replace the fuse holder in the housing and securely fix it.
