Event Lighting lite KONTROL48, Руководство пользователя

Страница: 7 / 11

www.event-lighting.com.au
7
2. Press Delete/Rev One three times.
Delete a Step
1. Enable Edit Mode for the scene to be edited.
2. Press Step to step through the steps of the scene until the desired step is selected.
3. Press Delete/Rev One .
4. Repeat steps 2-3 until all the unwanted steps are deleted.
Insert a Step
1. Enable Record Mode and record the steps to be inserted.
2. Enable Edit Mode for the scene where the steps are to be inserted.
3. Press Step to step through the steps of the scene until the step after the steps to be
inserted is reached.
4. Press Insert/% or 0-255 to insert the new steps. All channel indicator LEDs will flash.
Modify a Step
1. Enable Edit Mode for the scene to be edited.
2. Press Step to step through the steps of the scene until the desired step is selected.
3. Press and hold Down/Beat Rev to lower the value or Up/Chase Rev to raise the value.
4. Press or hold the Channel Flash button of the channel to be edited.
5. Repeat steps 2-4 until all modifications are made.
Playback Modes
Sound Active
KONTROL48 will respond to sound, either using the internal microphone or another device
plugged into the Audio In port. To use Sound Active mode:
1. Play back a scene
2. Press Audio/Page A/B .
3. Use the Audio Level fader to adjust the sensitivity.
Speed
The Speed fader will determine the amount of time between each step of a scene. When the
Speed fader is moved, the display will show
Speed _m_s_ , which indicates the time, in minutes,
seconds and milliseconds, between each step. The speed can range between 20 milliseconds
and 5 minutes or 10 minutes, depending on the mode.
The Speed fader has two modes: 5 minute and 10 minute.
To set the fader to 5 minute mode:
1. Press Record/Shift .
2. Press the Channel Flash button under 5/29 three times.
3. Release Record/Shift .
To set the fader to 10 minute mode:
1. Press Record/Shift .
2. Press the Channel Flash button under 10/34 three times.
3. Release Record/Shift .
To manually trigger the next step, move the Speed fader to
Show Mode (the lowest position).
When in Show Mode, press Step to trigger the next step.
Note : The Speed fader will have no effect if a beat is recorded or if Sound Active mode is
enabled.