www.event-lighting.com.au
5
Product Operation
Basic Operation
Page Selection
To switch between Page A (channels 1-24) and Page B (channels 25-48):
•
Press and hold
Record/Shift
•
Press
Audio/Page A/B
•
Release
Record/Shift
Master Faders
There are two master faders: A and B. Their functionality depends on which operation mode
KONTROL48 is set to. To switch between operation modes, press
Mode Select/Rec Speed
repeatedly. Below is a description of the available modes.
Crossfade Mode
•
Master Fader A controls the output of
Preset A
faders and Master Fader B controls the
output of
Preset B
faders.
•
Preset A and Preset B will always control the same 12 channels:
o
Page A: Channel 1-12.
o
Page B: Channel 13-24.
To use KONTROL48 in Crossfade mode:
1.
Move both Master Fader A and B to the bottom of the fader.
2.
Press
Mode Select/Rec Speed
until the
yellow
indicator for
1-12A/1-12B
is lit.
3.
Design the first look with faders in
Preset A
.
4.
Slide both Master Fader A and B up to the top simultaneously. This will activate Preset A.
5.
Design the next look with the faders in
Preset B
.
6.
Switch to
Preset B
by sliding both Master Fader A and B to the bottom simultaneously.
7.
Repeat steps 3-6 until finished designing.
Chase<>Scene Mode
•
Master Fader A controls the output of the faders in
Preset A
and Master Fader B controls
the total output of the current scene.
To use KONTROL48 in Chase<>Scene Mode, press
Mode Select/Rec Speed
until the
red
indicator for
Chase<>Scene
is lit.
To operate Master Fader B:
•
Move Master Fader B to its maximum position (fully down) for maximum effect. Adjust it
until the desired output for Record Mode and Scene Playback is reached.
To operate Master Fader A:
1.
Move Master Fader A to its maximum position (fully up) for maximum effect. Adjust it to
get the desired output.
2.
Move faders in
Preset A
to override the Master Fader A.
Important
: The recorded scene
will only be overridden if the position of the fader in Preset A is higher than the previously
recorded position.
Channel Mode
•
Master Fader A will control the output of all channels, and Master Fader B has no
function.
To user KONTROL48 in Channel Mode, press
Mode Select/Rec Speed
until the
green
indicator
for
1-24A
is lit.
