Evenflo Snulgi, Руководство пользователя

Страница: 35 / 76

1. Secure child restraint to the vehicle seat.
a
Restraint is securely locked into Recline Position #2
or #3 (p. 62).
a
Locking clip is installed, if necessary (p. 64).
a
If the child weighs 21.7 kg (48 lbs) or less, the
child restraint is securely installed with one of the
following methods through the
forward-facing
belt path :
• SureLatch Connectors (p. 34)
• Quick Connectors (p. 40)
• Vehicle seat belt (p. 45)
Note: To determine which type of LATCH connectors
are on your child restraint, go to page 34.
a
If the child weighs more than 21.7 kg (48 lbs),
the child restraint is securely installed with the
vehicle seat belt (not LATCH) through
forward-
facing belt path (p. 45).
a
Tether strap is attached and tightened (p. 39, 44,
or 48).
2. Place the child in the child restraint.
a
The child’s back and bottom are flat against the
back and bottom surfaces of the child restraint.
a
The tops of the child’s ears MUST be below the
top of the child restraint headrest.
3. Make necessary adjustments.
a
Harness tabs MUST be at shoulder level.
a
Headrest is adjusted so that its bottom is nearest
to the harness tabs (p. 62).
4. Fasten both buckle tongues.
Refer to page 14.
5. Position and connect chest clip.
a
Chest clip MUST be at armpit level (p. 15).
6. Check your work.
a
Harness is no more than two-finger widths
from child (p. 15).
a
To properly secure this child restraint, it MUST NOT
move more than 25 mm (1 inch) from side-to-side
or from front-to-back at the forward- facing
belt path.
Forward-facing Installation Checklist
33
For
ward-facing