49
48
2
3
1
2. Route aircraft seat belt through belt path.
Route the aircraft seat belt through the belt path
opening in the back of the child restraint and continue
through the opening on the opposite side of the child
restraint.
Note:
Lift the restraint’s seat pad away for easier access.
Aircraft
Seat Belt
Belt Path
Opening
PLACE
AT ARMPIT
3. Fasten the aircraft seat belt, then remove all
slack from the belt.
The aircraft seat belt must be as tight as possible.
Route the excess aircraft seat belt strap back through
the belt path opening. Using your full weight, push
the child restraint firmly onto the aircraft seat while
pulling on the excess seat belt strap to tighten.
Note:
Because of the fixed length of aircraft seat belts, the belt
buckle could be behind the child’s back after tightening the
belt. For your child’s comfort, Evenflo recommends cushioning
the child’s back by placing a small pillow or folded-up blanket,
or a folded-up jacket, over the belt buckle.
Check your work:
Reconnect the seat pad to the front
of the child restraint. Try to move the child restraint in all
directions. If you can move the restraint more than 25 mm
(1 in) from side-to-side or front-to-back
at the belt path,
the aircraft seat belt is not tight enough, and you
MUST
install again until the seat belt is tight.
4. Secure your child in the child restraint.
Refer to page
.
Gener
al
Removing the Seat Pad
1.
Disconnect the harness
straps from the splitter
plate.
2.
Disconnect elastic
loops and two
retaining strips.
Remove the seat pad.
Retaining
Strips
Elastic
Loops
Installing Child Restraint
in Aircraft (cont.)
WARNING
Cup holders
MUST
be installed before use of this Child
Restraint.
Snap each cup holder onto the seat, 1 and 2, then turn
the seat over and secure each cup holder with a screw
3, as shown. Do not overtighten. Make sure each cup
holder is attached securely in place.
Note:
Screws are provided in the small bag attached to
the harness.
Installing the Cup Holders
2
3
1
