27
26
Using your full weight,
push the child restraint
firmly into the vehicle
seat while pulling up
on the lower anchor
connector assembly
strap to tighten.
7
H
IMPORTANT: Make sure both lower anchor Quick Connectors
are facing upward and the straps are not twisted.
5
After the lower anchor connector assembly strap
E
has
been correctly inserted, it will appear as shown above.
Note: Make sure the adjustment buckle
F
is on the
correct side of the child restraint, as shown.
F
E
Refer to your vehicle owner’s manual to locate the
lower anchor bars on your vehicle seat.
Attach the left hook
A
, or clip
B
, to the left anchor
bar
G
, and the right hook to the right anchor bar.
DOUBLE CHECK
that each lower anchor connector
hook or clip is fully engaged by pulling hard on the
lower anchor connector assembly strap.
6
4
Insert the ends of the lower anchor connector assembly
strap
E
in the rear-facing belt path openings,
as shown (front openings). Note: Make sure the
adjustment buckle
F
enters the opening on the correct
side of the child restraint, as shown.
F
E
The lower anchor connector assembly strap must be
as tight as possible.
If you can move the child restraint more than 25 mm
(1 in.) side to side or front to back at the vehicle belt
path
H
, the lower anchor connector assembly strap
is not tight enough. You will need to try again, find
another location for your child restraint, or install with
the vehicle seat belt (page 20).
To remove the lower anchor connector assembly strap,
• To avoid a strangulation hazard, you
MUST
tightly roll or
fold excess tether strap and secure with the strap/rubber
band.
• Attach the tether hook to the storage clip when not in
use. This will keep an unused tether from hitting someone
during a crash.
When the tether strap is not
in use you
MUST
attach the
hook
I
to the back of the
child restraint, and tightly
roll and secure the strap with
the strap/rubber band.
A loose tether strap and
hook may injure your child.
I
8
G
A
Correct
Incorrect
B
G
Rear-facing
WARNING
