EVE WOLF, Руководство по эксплуатации

Страница: 11 / 12

11
In compliance with current safety standards, contact with the electrical parts of the oven must not
be possible once it has been installed
.
All parts, which ensure the safe operation of the appliance, must be removable only with the aid of a
tool
.
To fasten the oven to the cabinet, open the door of the oven and attach it by inserting the 4 wooden
screws into the 4 holes located on the perimeter of the frame
.
Electrical Connection
Those ovens equipped with a three - pole power supply cable are designed to operate with an
alternating current . The wire for earthling the appliance is yellow - green in color .
Fitting on a Power Supply Cable
•
Opening the terminal board :
· Using a screwdriver ,prize the bolt on the side tabs of the
•
terminal board cover ;
· Unscrew the bolt, pull open
the cover of the terminal
board
.
•
To install the cable, proceed as follows :
· Remove the wire clamp screw
and the three contact screws
L - N -
· Fasten the wires
•
beneath the screw heads using the following color scheme : Blue ( N ) Brown ( L ) Yellow - Green
· Fasten the supply cable in place with the clamp and close the cover of the terminal
board
.
•
Connecting the supply cable to the mains
•
Install a standardized plug corresponding to the load indicated on the data plate . When
connecting the cable directly to the mains, install an omni polar circuit breaker with a
minimum contact opening of 3 mm between the appliance and the mains
. The omni polar
circuit breaker should be sized according to the load and should comply with current
regulations
( the earth wire should not be interrupted by the circuit breaker ).
•
The supply cable should be positioned so that it does not reach a temperature of more than
50
℃
with respect to the room temperature ,anywhere along its length , or protected by
insulation sleeping having an appropriate rating .
•
Before making the connection, check that :
· The electrical safety of this appliance can only be guaranteed if the cooker is
correctly and efficiently earthed ,in compliance with regulations on electrical safety
.
Always ensure that the earthling is efficient; if you have any doubts call in a qualified
technician to check the system
. The manufacturer declines all responsibility for
damage resulting from a system which has not been earthed .
· Before plugging the appliance into the mains ,check that the specifications indicated
on the date plate
( on the appliance and / or packaging ) correspond to those of the
electrical mains system of your home .
· Check that the electrical capacity of the system and sockets will support the
maximum power of the appliance ,as indicated on the data plate
. If you have any
doubts, call in a qualified technician .
· If the socket and appliance plug are not compatible ,have the socket replaced with a
suitable model by a qualified technician
. The latter, in particular, will also have to
ensure that the cross section of the socket cables are suitable for the power
absorbed by the appliance
. The use of adapters, multiple sockets and / or extensions,
is not recommended . If their use cannot be avoided, remember to use only single or