EVCO S.p.A.
Vcolor
| Hardware manual ver. 1.0 | Code 144VCOE104
page 17 of 38
6
PRELIMINARY INFORMATION
6.1
Switching on/off the device
To switch on the device, operate as follows:
1.
Connect the power supply: i twill be started an
internal test.
The test takes typically a few seconds.
2.
To the end of the internal test press and release
the area in the bottom right-hand corner of the
display: the display will show the sensitive areas.
To switch off the device, operate as follows:
3.
Switch off the power supply.
6.2
Access to the menu “Info”,
“Diagnostic” and “Debug”
To gain access to the menu “Info”, “Diagnostic” and “Debug”,
operate as follows:
1.
Switch on the device and show the sensitive
areas; look at paragraph 6.1 “Switching on/off the
device”.
2.
Press and release the area “USER”: the display will
show the menu “Network Status(CAN)”.
3.
Press and release the area “ENTER”: the display
will show the menu “V-COLOR PROG”.
4.
Press and release the area “DOWN” to select the
menu
(for
example
to
select
the
menu
“Diagnostic”).
5.
Press and release the area “ENTER”.
To quit the procedure, operate as follows:
6.
Press and release over and over again the area
“ESCAPE”.
Showing the sensitive areas
Selecting the menu “Diagnostic”
