SCOOTER OPERATION
Control Panel
handle bars. Squeeze the left hand side of the
wigwag paddle (BLACK) towards you and the
scooter will move backwards, emitting an audible
reverse alarm. To brake, release the wigwag
paddle which will return to neutral and activate
the electromagnetic brake automatically and
bring the scooter to a prompt stop. The wigwag
paddle allows you to control the speed of the
scooter up to a maximum speed determined by
the Speed Dial. The further the wigwag paddle is
deflected, the faster the scooter will go (up to
3.5mph).
Warning
Do not operate both left and right hand
sides of the wigwag simultaneously.
You will not be able to control the
scooter.
How To Operate Your Scooter
•
Key Ignition. The key ignition acts as the power
switch for the scooter. To switch the power on,
turn the key clockwise and battery gauge should
illuminate. To switch the power off, turn the key
counter-clockwise, after which the battery gauge
should switch off and the key can be removed.
Do not turn the ignition off while riding as
this will lead to an emergency stop and
possible risk of damage or injury.
•
Speed Dial. Turn the speed dial to determine the
maximum speed of the scooter. Turn the dial
clockwise to increase the speed setting and turn
the dial counter-clockwise to decrease the speed
setting.
Do not adjust the speed dial while riding
as this could result in loss of control. Do
not set the highest speed while riding
indoors.
•
Moving and Braking. To move forward, squeeze
the right hand side (RED) of the wigwag paddle
with your hand towards you while holding the
•
Horn Button. Press the horn button to sound the
horn. Release the button to stop the horn. The
horn is the green button located on the control
panel.
•
Braking
–
Electromagnetic Brake. Release the
wigwag paddle completely, and the
electromagnetic brake will be activated
automatically and the scooter will stop.
When on a gradient, never set the vehicle
to freewheel mode. The brakes will not be
applied.
•
Light. Press the light switch to turn on the
headlight. Press the light switch again to turn the
light off.
Note: the light will only operate if the power is
switched on at the ignition.
•
Handlebar Height Adjustment. Turn the large
adjustment knob on the front of the tiller
anticlockwise to release the handlebar. Slide the
handlebar to the required position, then turn the
knob clockwise to secure the handlebar in place.
