Manual instruction MM850482 ed.04
16
6 OPERATIONS
All the procedures and programming operations on
UniGas 1000
can be made using the keyboard and the
display.
N
OTE
:
ALL NUMERIC VALUES SHOWN IN THE FIGURES OF THIS MANUAL ARE INDICATIVE AND LISTED AS AN EXAMPLE
.
The analyzer should be used in environments where the temperature does not exceed the specified limits
(from -5°C to +45°C) and where the relative humidity is lower than 95% non-condensing.
6.1 Flue
Gas
Analysis
6.1.1
Switch the instrument ON
Connect the gas probe to the analyzer as shown in chapter 6.
DO NOT INSERT THE PROBE IN THE
CHIMNEY/ STACK WHEN UNIT IS GOIG THROUGH ITS 60 SECOND AUTO CALIBRATION.
Switch the analyzer on pressing the [
ON
] key. The display will show the following page:
This page changes automatically after a few seconds or if you press a key as follows:
This page changes automatically after some a few seconds or if you press a key as follows:
This page displays the remaining seconds until the end of the autozero procedure.
N
OTE
: T
HE ANALYZER MUST DRAW CLEAN AMBIENT AIR FROM THE AMBIENT DURING THE AUTOZERO PROCEDURE
.
O
THERWISE THE MEASUREMENTS MAY NOT BE ACCURATE AND A SENSOR ERROR MAY OCCUR
.