4
Step 4.
Install the front main frame as in Fig. 4
1. Locate the front main frame section as shown in fig 4..
2. Slide the front main frame tube inside the rear main tube of the rear axle
assembly.
(note the front section has a shaped end that when inserted correctly locates
around the rear axle)
3. Place the seat assembly in position and line up the holes for the frame through
bolts.
4. Using the long through bolts insert them through the seat assembly bracket and
through both tubes of the main frame.
5. Place one washer and one dome nut on each bolt and tighten securely using the
Fig. 4
Fig. 5
Step 5.
Install the front mudguard as shown in
Fig 5.
1. Locate the front mudguard and front
wheel assembly.
2. Slide the mudguard from the top over
the steering tube of the front wheel
assembly making sure the slot in the
steerer tube is towards the back.
wrench
3
Step 2.
Install the rear wheels as in Fig. 2
1. Slide the Right hand wheel onto the rear axle assembly.
2. Insert the rear plastic hub cap throught the centre of the wheel. (note the hole in
the hubcap should be lined up with the hole in axle assebly at the bottom) Push the
hubcap all the way on so the two holes line up.
3. Place the small self tapping screw through the hole in the axle and screw into the
hupcap using a phillips head screwriver. Ensure the screw is tight and test that the
wheel can rotate freely. (Dont worry if the wheel is a little tight as it will begin to spin
freely when used.)
4. Follow the same procedure for the Left hand wheel
Fig. 2
Step 3.
Install the seat to the seat bracket as in Fig. 3
1. Locate the saddle bracket and the saddle. Locate the 2 long bolts, 2 whashers
and 2 nuts as shown in fig 3.
2. Pass the two bolts through the seat from the top and through one of the positions
in the saddle bracket. Install one washer and one nut on each then tighten using a
philips head screw driver whilst holding the nut with the adjustable wrench.
Fig. 3
