3
Read the ENTIRE IMPORTANT SAFETY INFORMATION
section at the beginning of this document before using this
product.
CHARGING INSTRUCTIONS
1.
Attach the power cord of the Charger (5) into the bottom of the
Shaver (1). Plug the Charger into an electrical outlet that is
away from any source of water.
Note:
Make sure the Shaver
Switch (8) is turned to OFF.
2.
Once plugged in, the LED charger light on the front of Shaver
housing will activate.
3.
Charge for 5 to 7 hours. Do not charge for longer than the
required charge time.
OPERATING INSTRUTIONS
1.
Once fully charged, remove the Charger cord from the
housing, remove the Cover (4) and turn the switch to ON.
2.
Gently guide Shaver over your skin. Use short back and
forward strokes and do not apply too much pressure
.
3. If you have not used an electric shaver before your skin may
become irritated. This is a natural reaction that may last for a
few days until your skin adjusts to the shaver.
4.
When finished shaving, turn the switch to OFF.
5.
Slide the Cover onto the Shaver head until ready to use again.
When travelling keep the shaver in the Carrying Sleeve (7).
CLEANING THE SHAVER
1.
After each use cuttings will collect in the Foil.
2.
Clean the Foil by rinsing the Shaver head under cool running
water.
3.
WARNING!
Only clean when Shaver is disconnected from
the Charger and the switch is turned to
OFF
.
4.
Hair trimmings may get under Foil and/or it may be necessary
to replace Foil. First, press down on the tabs on either side of
the Foil Holder (3).
5.
Slide Foil Holder off of the top of Shaver housing, exposing
the Shaver cutting heads.
6.
If necessary, use the Brush (6) to clean trimmings from the
exposed Shaver cutting heads.
6. If required, slide the old Foil from out of the Foil Holder and
rinse the trimmings away.
7. If the Foil needs replacing, slide the new Foil into the Foil
Holder so that small hole in the centre of the Foil slides over
the small tab in the middle of the Foil Holder cross bar. This
will hold the Foil in place.
