Eurotherm 582, Руководство по эксплуатации продукта, Страница: 18 / 47

Chapter 5 Terminal Descriptions
5 - 6 582/583/5831
SW7 SW8
(OFF) (OFF)
(OFF) (ON)
(ON) (OFF)
(ON) (ON)
- Stopping Mode
:
:
:
: Coast to Stop.
Ramp down to Stop.
Ramp to zero followed by 2 sec DC holding pulse.
DC Injection Braking. (See Note 2).
SW9 Ramp Hold : This switch should normally be off. (See Note 3).
SW10 SW11 SW12 Power
Output Drive
(OFF)
(ON) : 0.37kW
0.55kW
582 0.37/0.55kW
1
(OFF)
(ON) : 0.55kW
0.75kW
582 0.55/0.75kW
1
(OFF) (OFF) (ON)
(ON) (OFF) (ON)
(ON) (ON) (ON)
:
:
: 0.75kW
1.1kW
1.5kW
583 1.1/1.5kW
1
(OFF) (ON) (OFF)
(ON) (ON) (OFF)
:
: 1.5kW
2.2kW
583 1.5/2.2kW
1
(OFF) (OFF) (ON)
(ON) (OFF) (ON)
(ON) (ON) (ON)
:
:
: 0.37kW
0.55kW
0.75kW
5831 0.75kW
1
(OFF) (OFF) (ON)
(ON) (OFF) (ON)
(ON) (ON) (ON)
:
:
: 0.75kW
1.1kW
1.5kW
5831 1.5kW
1
NOTES:
1. Controllers are shipped with switches set to the lower rating. Set switches to the required
rating before use. Setting of the switches on the 583 1.1/1.5kW version to 2.2kW will
cause damage and invalidate the warranty.
2. DC injection braking may be selected by setting switches 7 and 8 to the ‘on’ position.
When a stop command is received, the drive will apply a low frequency braking current to
the motor, until the shaft is almost at a standstill. The amount of braking is controlled by
the current limit setting.
DC current is then applied for a short time, to bring the shaft finally to a standstill. This is
controlled by the boost adjustment.
3. To achieve very fast ramp up rates, e.g., 0.1 seconds, it may be necessary to set this switch
to ‘on’.