Eurotherm 3200, Руководство пользователя

Страница: 29 / 174

Part number HA028582. Issue 6.0 May-07 27
4. Switch On
A brief start up sequence consists of a self test in
which all elements of the display are illuminated and
the software version number is shown. What happens
next depends on one of two conditions:-
1.
The controller is new and has been supplied un-
configured (go to section 4.1)
2. The controller has been supplied configured in
accordance with the Quick Start code (go to
sectio 4.3).
4.1 Initial Configuration
If the controller has not previously been configured it
will start up showing the ‘Quick Configuration’ codes.
This is a built in tool which enables you to configure
the input type and range, the output functions and the
display format.
!
Incorrect configuration can result in
damage to the process and/or personal injury and
must be carried out by a competent person
authorised to do so. It is the responsibility of the
person commissioning the controller to ensure the
configuration is correct
The quick code consists of two ‘SETS’
of five characters. The upper section
of the display shows the set selected,
the lower section shows the five digits
which make up the set.
Adjust these as follows:-.
1.
Press any button
.
The first character will change
to a flashing ‘-‘.
2. Press
V
or W to change the flashing
character to the required code shown in the quick
code tables –see next page. Note: An
x
indicates that the option is not fitted.
3. Press

to scroll to the next character. If you
need to return to the first character press .
When all five characters have been configured
the display will go to Set 2.
When the last digit has been entered press

again,
the display will show
Press
V
or W to .
The controller will then automatically go to the
operator level.