Eurotech H75.6P, Инструкция по эксплуатации

Страница: 6 / 6

3
RANGE HOOD
5. Notice of Installation
5.1 Before installation, please make sure that there is adequate
ventilation of the room when the range hood is used at the same time
as appliances burning gas or other fuels and clean up the surrounding
area, to avoid suction of the such as bits of broken wood.
5.2 It can not share the same air ventilation tube with other appliance
such as gas tube, warmer tube, and hot wind tube.
5.3 The bending of soot ventilation tube should be
≥ 120°C, parallel
or above the start point and should be connected to the outdoor.
5.4 After installation, test carefully on the horizontal degree,
see pic7.
5.5 Be sure that the plug is accessible after installation.
6. Safety Warning
* There must permanent & adequate ventilation of the room when operating
the range hood with appliances burning gas or other fuels.
* Do not check the status of the filters when the range hood is operating,
wait at least 30 minutes after switching off to avoid scalding.
* Do not touch the (Halogen) light within 30 minutes after appliance use.
* Avoid operating a gas cooker when there is no pan on the stove, it is a fire
hazard and may cause damage to the hood filters.
* Disconnect the electrical plug prior to any maintenance.
* This appliance is not intended for use by young children and persons
unless they have been adequately supervised by a responsible person to
ensure that they can use the appliance safely.
PIC 7
4
User’s Manual
* The range hood is for home use only and is not suitable for outdoor,
barbecue, and other commercial applications.
* The range hood and its filter should be cleaned regularly for best
performance. Excessive grease will impede airflow and may cause the motor
to overheat.
* Before cleaning, please confirm that the power is switched off.
* Building regulations concerning the discharge of exhaust air have to be
fulfilled.
* Don’t cook with an open flame under the range hood.
* For any technical issues ensure that a suitably qualified person effects any
repairs or inspection.
7. How to Use
* Push the Low button, and the motor runs at low speed.
* Push the Mid button, and the motor runs at mid speed.
* Push the High button, and the motor runs at high speed.
* Push the Light button, and the lamp illuminates. Push it again and
the lamp will turn off.
* Push the Stop button, and the motor will stop.