EUROPRO MIXPRO 14, Руководство пользователя

Страница: 7 / 16

201306-021-ENG User Manual - MIXPRO 14 - V3 P7
USER GUIDE
STARTING UP/STOPPING THE MACHINE:
• Once the machine is connected, the machine is in the stop setting, the display (A) indicates “OFF”.
• By pressing the “Start/Stop” button (1), the display (A) indicates the set point of the flow produced,
the light (L1) is switched on, the machine is operational.
• By pressing the “Start/Stop” button (1) when the machine is operational ((L1) light is switched on)
the machine moves to the stop setting, the display (A) indicates “OFF” ((L1) light is switched off).
• Pressing the button (7) allows the machine to be operated with or without water ((L6) light is switched
on = with water, L6 switched off = without water).
• When the (L6) light is on, the machine is set to continuous mixing with water (for powder products)
• When the (L6) light is out, the machine is in the without water setting (for paste products)
In the event of the machine malfunctioning, holding down the “Start/Stop” button (1) for more than 3
seconds, allows you to check that the supply voltage is above 210 Volts.
• By pressing the “MANU” button (2) the product pump starts and the (L2) light is switched on.
• By pressing the “ARRIÈRE [REVERSE]” button (3) the product pump rotates in the reverse direction
and the (L4) light is switched on.
• Buttons (4) and (5) control the rotation speed of the product pump.
• In the case of using a powder product, pressing the button “REMONTÉE D’EAU [WATER INTAKE]“
(6) causes water to enter into the mixing chamber. This function should only be used when starting
the machine between adding the first powder product sack.
• In AUTOMATIC setting with water ((L6) light is on), the opening of the spray gun or operation command
causes the machine to start up. The automatic cycle manages the operation of the product pump,
the water pump and the input of water into the mixing chamber.
• In AUTOMATIC setting without water ((L6) light is off), opening the spray gun or operation command
causes the machine to start up. The automatic cycle manages the operation of the product pump,
intake of water into the mixing chamber even when the “WATER UPFLOW“ button (6) is inactive.
FAILURE CODES
The following failure codes may be displayed on the display screen (A).
CODES DEFINITIONS ACTIONS TO BE TAKEN
No display. Plug in the machine, check electricity supply (230V), check the fuse
inside the electrical box.
Emergency stop
engaged.
Switch off emergency stop button (AU)
Machine in off
setting.
Press button (1) to start the machine
Motor control
failure.
Turn the machine “OFF” for one minute then restart.
Safety sensor
failure.
Check the safety grille is securely closed.
Water pressure
failure Only if L6 is
lit.
Check the water pressure on the manometer, check the water
intake: Pressure > 2 bars or sufficient flow.
Start up command
active on starting
the machine
Close the spray gun or set the remote control to “OFF”. Clean the
flowmeter (dismantling the piston).