EUROPRO 40095, Руководство пользователя

Страница: 14 / 36

User manual - X-PRO D200 202203-577-ENG P14
4. USE OF THE MACHINE (continued)
4.2. MACHINE STARTING UP
1. Place the machine horizontally by lowering or raising the jockey wheel (9) so that the machine is
stable and level.
2. Unlock the emergency stop (11) on top of the fixed polyester hood.
3. Place the contact key in the ON position. The engine will increase its speed from idle to the maximum
speed previously selected on the knob (20).
4. Let the engine run for 5 to 10 minutes to warm up before continuing work.
5. Fill the hopper with approx. 30 litres of water.
6. Check the pump pressure and adjust if necessary (see procedure below).
7. Connect the remote control cable to the socket if necessary for the work to be done (remote control
cable not supplied with the machine equipment) .
8. Connect the product hose to the pump outlet (8).
9. Turn the selector (17) to the left so that the pump turns to the FORWARD position.
10.
Run water through the hose and then empty the hose.
11. Prepare a mixture of water and liquid cement and pour it into the hose.
12. Empty the remaining water in the hopper by opening the plug for this purpose.
13. Pour the product to be used into the hopper. The machine is now ready to work.
14. During use, use the control (16) to adjust the product flow rate.
PUMP PRESSURE CONTROL :
• Pour water into the tank.
• Connect the control hose to the pump outlet (8).
•
Set the flow rate to maximum.
• Turn the switch (17). When water comes out, close the valve of the pressure controller and read the
value on the manometer (7).
• To adjust the pump pressure, tighten or loosen the screws on the pump.
Never run the screw without product or water.
The screw rotation control knob has a preferential direction characterized by a held position.
Reverse rotation is possible by holding the knob manually in the RIGHT position.