European Water Care EWC 10, Руководство пользователя

Страница: 10 / 24

Version 1. 1/12 10
5. Manually turn the control clockwise to the ‘Brine + Rinse’ position and allow the control
to draw water from the brine tank, until it stops drawing, (leaving approximately 2 inch of
water in the brine tank, this takes approximately 10 to 12 minutes). Note: if at this stage the
brine tank fills instead of emptying. Check:

Your inlet and outlet connections are correct

The drain hose is not kinked

You have a reasonable water pressure (at least 1.5 bar)
6. Set the control knob to the correct time of day. The time of day is indicated at the bottom
of the control knob by the numbers 1 to 12, a or p, (‘a’= am & ‘p’= pm). To set the time of
day press and hold the red button and turn the large gear until the present time appears in the
window. This is purely to ensure the water softener regenerates at night (approximately
2 am) so that no water is used by the household during the regeneration, therefore only the
hours are required to be set and not minutes. It is not absolutely necessary to reset this clock
for summer and winter time provided the softener regenerates when no water is being used as
described previously. It should be reset after a powercut to approximately the correct time.
7. Set the days you would like regeneration to occur (see ‘Regeneration Schedule’ Fig 10)
Each tab represents a day (Fig 7). If you pull the relevant tab outwards (towards you) the
softener will regenerate on that night. If you push the tab in – it will not.
So -
* To set the softener to regenerate every night, pull out all the tabs.
* To set the softener to regenerate every other night i.e. every 2 days – pull out alternate tabs
* To set the softener to regenerate every third night – pull out one tab, push in the next two
tabs - etc.
Fig 7

Each tab is one day

Finger at red pointer is tonight.

Moving clockwise from the red pointer, pull or push fingers to obtain the desired
regeneration schedule. (Fig 8 & Fig 9)