EuropAce EWC 8041S, Инструкция по эксплуатации, Страница: 5 / 23

INSTALLATION INSTRUCTIONS FOR BUILT IN WINE CELLARS
4.
1.
Europace
“Built in” wine cellars are front venting but are not designed to be fully
integrated behind a joinery door.
2. Please follow the installation diagram when installing built-in wine cellars. No less than
the minimum installation dimension, or it will affect the venting of cellar.
3.
Europace
“Built in” wine cellars draw air from right of ventilation frame and expel
through left of ventilation frame under the front door.
4. Europace “Built in” wine cellars have a power switch located on the control panel so
power point location is not critical.
5. The wine cellar requires a standard 240 volt/10 amp power point. (Or according to
different countries specifications).
6. The power cord is 2.0m in length and is fixed on the right side at the back when looking
from front of cabinet.
7. As with most appliances of today, the wine cellar has sensitive electronic components
which are susceptible to damage through lightning and electricity supply faults. It is
therefore advised to use a power surge protector to avoid problems of this nature.
8. Air vent on door must be provided for
Europace
built-in wine cellars when a wood door
installed.
In Hot climate zone, an air vent or grid, with a minimum ventilation size of 200mm x 40mm
MUST be cut out at the rear top of the back partitioning or at the top of either side of the
partitioning, allowing cool fresh air full access to flow into the 30mm gap located at the rear
of the cabinet.
This air vent or grid must not be opened on the same side as other appliances such as ovens
or an area that is sealed and without access to fresh cool air. Failing to comply with the
above specifications could result in WARRANTY void.