Euromaid IHT60, Инструкция по установке и эксплуатации

Страница: 17 / 23

EN 16
Error reason Display
Ambient light to high F1
Strong pulsating light (fluorescent
tube)
F2
Sensor covered with a bright object F3
Strongly fluctuating ambient light F4
Calibration error AX
Induction hardware error EX
Table -3:
Error codes and source of errors
(
X= “0....9”)
After a successful calibration the function of
the hob is also guaranteed even with strong
illumination, for example with halogen spot with
reflector (50W).
In case of an error, the calibration is repeated
until the ambient conditions allow a successful
calibration. The operation of the hob control
is only possible, if the calibration of all sensors
were successfully completed.
After successful finished calibration process
the control tolerates a very high rate of ambient
light.
During the operation of the hob control, it
continuously adopts and recalibrates itself
towards the changes in the ambient conditions.
Application Example:
The calibration performs without any
problems if the following illumination
is present:
Illumination through a light bulb
without reflector (100W, opal) in a distance of 70
cm above the glass ceramic hob.
Please see Table 3 for information
on explanations related to the
error messages that can appear
on the touch control display.
• In the event that the touch control
surface is closed for a period longer than
10 seconds, the entire control system will
be deactivated and a warning signal will
sound. Also “F” flashes on the hotplate
display.
• If the surface of the touch control is
exposed to dense vapour, the entire control
system will be deactivated and a warning
signal may be given.
• Keep the surface of the touch panel clean.
Otherwise, malfunctioning may occur.
Noises
Some sounds may be heard from induction
heated hob. Such sounds are normal and a part
of cooking with induction. Such sounds;
• may be intensified when the level is in high
power position.
• may arise from the structural materials of the
pan.
• In low power positions, a regular on-off sound
can be heard due to the operating principle.
• Sound can occur while heating an empty pan.
Such sound will disappear when you add water
or food in it.
• Noise of the fan which is used to cool the
electronic system can be heard.
Sensor Calibration and Error
messages
The hob control performs an automatic
calibration in reference to the sensor-, glass-
and ambient conditions after the main voltage
is applied. Do not cover the glass area of the
sensor during the calibration. In addition, the
hob control must not be exposed to strong
illumination, like sunlight, strong halogen lights
and etc.