Euromag MUT1000EL, Инструкция по эксплуатации, Страница: 7 / 54

7 / 54 7 / 54
Sensors
EUROMAG | SENSORS | Ed. 04/2019
1.3 PRELIMINARY NOTES
Main parts of the electromagnetic flowmeter are:
»
Sensor – installed in the tube with the use of flanges and other joints
»
Converter
– can be installed on the sensor (in compact version) or remotely (in remote version)
connected with two pipes
Electromagnetic flowmeters have many important advantages compared to their mechanical counterparts,
such as exceptional long-term stability, maximum process reliability, and zero maintenance. As a result,
these sensors can provide accurate and reliable long-term measurements.
See the following paragraphs for more detailed information on correct installation.
NOTES:
Electromagnetic flowmeters are designed specifically to operate under the following basic
conditions:
1. The liquid must be conductive;
2. Pipe must be always full and free from air and bubbles;
3. The input and output distances must be on recommended settings
4. The grounding instructions must be followed
1.4 PRODUCT IDENTIFICATION
Each Sensor manufactured by EUROMAG INTERNATIONAL has an identification plate (Fig. 1) that
displays the following information::
IDENTIFICATION PLATE
»
MODEL: Sensor model
»
S/N: Sensor identification number
»
DN: Nominal diameter [inches or mm]
»
PN:
Nominal diameter [inches or mm]
»
TEMP.: Maximum liquid temperature for process
completion
»
IP: International degree of protection
»
ELECTRODES: Electrodes material composition
»
LINING:
Lining material
»
KA: Calibration coefficient
»
CE: Marking
Fig. 1 Identification plate
The identification plate must never be removed, damaged, or changed. It must also be kept
clean from any dirt deposits, as the data contained are the only safe and unambiguous way to
recognize the type of converter and be able to complete the repair request form attached to this
manual.